Assembly; Mounting Your Saw - RIDGID TS2424 Owner's Manual

Assembly

Mounting Your Saw

1. From the bag labeled "Legs" remove the following
hardware:
4 Hex Head Screws, 5/16-18 x 1-1/4" Long
4 Hex Nuts, 5/16-18
4 Lockwashers, 5/16" External Type
8 Flat Washers, 11/32 x 11/16 x 1/16
2. Place the saw upside down onto a smooth piece of
cardboard or heavy paper, on the floor, so the saw is
resting on the table top.
WARNING: The saw is heavy. To reduce the risk of
back injury, get help to lift the saw. Hold the saw
close to your body. Bend your knees so you can lift
with your legs, not your back.
3. Place legs on saw so that holes in saw base and leg
set line up and trim label is facing front.
4. Install screw, washers, lockwasher and nut as shown.
5. Tighten all leg assembly and mounting hardware at
this time.
Hex Nut
Lockwasher
Flat Washer
End Stiffener
Flat Washer
Hex Head Screw
Bench Mounting
If you do not use the legset and mount the saw on a
bench, make sure that there is an opening in the top of
the bench the same size as the opening in the bottom of
the saw so that the sawdust can drop through. Recom-
mended working height is 33 to 37 inches from the top of
the saw table to the floor.
Leg Set
Cardboard
Saw Base
20
5/16-18 x 1-1/4 In
Hex Head Screw
5/16 In External
Lockwasher
7/8 11-1/4
+
13
Bench
Opening
15-3/4
+
Front of Saw
NOTE: All dimensions in inches
5/16-18
Hex Nut
11/32 I.D.
Flat Washer
7/16 Dia.
Mounting Holes
+
16-3/4
+
1/2