Checking Table Insert - RIDGID TS2424 Owner's Manual

Assembly (continued)

Checking Table Insert

WARNING: To reduce the risk of injury from acci-
dental start, make sure switch is "OFF" and plug is
not connected to power source outlet.
1. Insert should be flush with table top. Check as shown.
Loosen flat head screw that holds insert and adjust the
four set screws as necessary. Tighten flat head screw.
Do not tighten screw to the point where it bends the
insert.
CAUTION: Insert must be even with the table sur-
face. Inserts too high or low can let the workpiece
"snag" or catch on uneven edges. Workpiece
could twist and kickback.
2. To remove insert.
a. Make sure saw is off and unplugged.
b. Loosen flat head screw.
c. Lift insert from front end, and pull toward front of saw.
3. To replace insert.
a. Make sure saw is off and unplugged.
b. Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert will drop over flat head screw.
Tighten screw.
c. Do not tighten screw to the point where it bends the
insert.
3/32 In.
Hex "L" Wrench
Flat Head
Screw
22
Table Insert
Set Screws