Installing Elevation Handwheel; Assembling Leg Stand - RIDGID TS3650 Operator's Manual

.SP6498 Belt Drive Saw 05/03
Assembly (continued)

Installing Elevation Handwheel

1. Locate the following hardware:
1 Handwheel
1 Elevation Lock Knob
1 Elevation Lock Tube
2. Slide elevation lock tube onto
elevation shaft.
3. Line up flat spots on shaft and
handwheel, push handwheel onto
shaft.
4. Screw elevation lock knob onto
shaft. Do not tighten at this time.

Assembling Leg Stand

1. Locate the leg stand.
Remove all parts from packing
material.
2. Locate the following hardware:
23 Truss Head Screws,
5/16-18 x 5/8" long
23 Serrated Flange Hex Nuts,
5/16-18
4 Leveling Feet
8 3/8-16 Hex Nut
3. Locate the following:
4 Legs
2 End Panels
2 Leg Braces
1 Miter Gauge Storage Hook
2 Rip Fence Storage Hooks
4 Foot Stiffeners
7/15/03 7:04 AM Page 18
Elevation
Lock Knob Lock Tube
Elevation Handwheel
Elevation Lock Knob
5/16-18 x 1/2 In.
Head Screw
3/8-16
Hex Nut
Leg
Miter Gauge
Storage Hook
18
Elevation Handwheel
Elevation
Lock Tube
5/16-18 Serrated
Flange Hex Nut
Leveling
Foot
Rip Fence
Storage Hooks
Leg
Braces
Rip Fence
Storage
Hook
End Panel
Foot
Stiffener