Creating An Old Movie Effect - Matrox RT.X2 User Manual

122

Creating an old movie effect

The Matrox old movie effect lets you create an old film look on your clips by
adding noise, dust, streaks, jitter, and flickers.
° To set up a Matrox old movie effect:
Click the triangle beside Matrox Old Movie to expand the property list.
• Random Artifact Generator Adjust this setting to change the placement
of artifacts in your clip. The artifacts are randomly distributed based on the
value you select. For example, if you notice the streaks in your clip are
always in the same place, you can use this setting to move them.
• Border Settings
$
$
• Preprocessing These controls allow you to isolate a channel to process
black and white values for your effect. For example, to adjust black and
white values on the red channel only, select Red Only as your mode.
$
¦ Note
the color of your clip. If you would like your clip to remain black and white,
select Lock Colors for both the Color Gain and Color Addition .
$
Chapter 4, Setting Up Realtime Effects with Adobe Premiere Pro
Round Corner Size
your clip.
Softness Lets you adjust the amount of softness on the edge of your clip
by dragging the slider or entering a percentage in the text box. The higher
the value, the less sharp the edge will become.
Enable Preprocessing
Enabling this option will turn your clip black and white.
Adjusting the Color Gain and Color Addition controls will change
Mode Lets you select the channel you want to use for the processing.
Click the triangle on the right to expand the list.
Red Only Uses the red channel.
•
Allows you to round the corners on the edges of
Select this option to enable preprocessing.