Printing On Both Sides Of The Paper (Manual Duplexing) - Xerox Phaser 3310 User Manual

Printing on Both Sides of the Paper
Note:
If you can not see Flip
on Long Edge in the Type
drop-down list, set the Type
box in the Output Mode
section to Multiple Pages per
Side, Scaling Printing or Fit to
Page.
To print on both sides of the paper (manual duplexing), you
must run the paper through the printer twice. You can print
using the top output tray (face down tray) or the rear output
tray (face up tray). Xerox recommends using the top output
tray for light-weight paper. Use the rear output tray for any
heavy media or media that tends to curl when printed, such as
envelopes and card stock.
Note:
To print on both sides of the paper, you must use the
Multi-Purpose Tray for the paper input source. Load paper in the
Multi-Purpose Tray.
1
When you change the print settings from your software
application, access the printer properties. See
access the printer properties.
From the Paper tab, select the paper orientation, source,
size and type.
2
Click the Output tab, then choose Flip on Long Edge or
Flip on Short Edge from the Type drop-down list in the
Manual Duplex Printing section.
(Manual Duplexing)
page 5.2
P T
RINTING ASKS
to
5.7