Xerox Phaser 3310 User Manual page 164

CONFIG
• Emulation You can select the emulation for printing a document
between AUTO and PCL. The factory default is AUTO.
• Power Save determines the length of time the printer waits
after a job is printed before it goes to a reduced power state. If
the printer is used frequently, select OFF which keeps the
printer ready to print with the minimum warm-up time. This
uses more electricity to keep the printer warm and ready to
print.
• Auto Continue determines what action the printer should take
when a manual feed print job is sent to the printer and there is
no paper in the Multi-Purpose Tray. If it is checked, the printer
will pick up the paper from the standard Tray 1 or optional Tray
2 after fifteen seconds. Otherwise, the printer will wait for you
to load paper in the Multi-Purpose Tray.
• Jam Recovery determines what action the printer should take
when a paper jam occurs. If it is unchecked, the printer does
not reprint a page that has jammed. If it is checked, the printer
keeps the image in memory for a printed page until the printer
signals that the page has successfully printed. The printer
reprints all jammed pages.
• Econo Mode determines the toner quantity the printer should
use when printing. If it is checked, the printer conserves toner
when printing. The default value is unchecked, which provides
100% usage.
Selecting Print Settings
P DOS A
RINTING FROM PPLICATIONS
C.7