Xerox Phaser 3310 User Manual page 146

Network Connection
If you have a printer with 10/100Base-TX network interface
card installed (Option), you can connect to an Ethernet
network. Use a Category 5 twisted pair cable with RJ-45
connectors for 10/100Base-T Ethernet.
1
Plug one end of the network cable into the twisted-pair
connector on the back of the printer.
2
Connect the other end to the network hub.
Note: You must configure your printer for the network.
For information about configuring your printer, refer to
the Network User Guide.
Macintosh Installation
U Y P
SING OUR RINTER WITH A
B.3
M
ACINTOSH