Memory And Postscript Simms - Xerox Phaser 3310 User Manual

Memory and PostScript SIMMs

Additional printer memory and the PostScript option are provided on SIMMs (single in-line
memory modules). This procedure is applicable to either option.
Note:
Since PostScript setting requires 12 MB of printer memory and the Phaser 3310 comes
with 4 MB standard, installation of the PS SIMM requires installation of a 8 MB SIMM
memory as well (supplied as part of PS Option Kit).
1
Turn the printer power off and unplug
all cables from the printer.
2
Remove the two screws on the rear of
the printer, then remove the control
board cover.
3
Locate the PS SIMM slot (the lower slot
on the left as shown) and the memory
SIMM slot (the upper slot) on the
control board. They are not
interchangeable.
• To install the memory SIMM, continue
with Step 4.
• To install the PS SIMM, go to
F.2 P O
RINTER PTIONS
Step 6.
Memory
DRAM MODULE
FLASH-ROM MODULE
PS SIMM