Removing A Power Supply - IBM System x3610 User Manual

5. Connect the power cord for the new ac power supply to the power-cord
6. Route the power cord through the power-supply handle and through any cable
7. Connect the power cord to a properly grounded electrical outlet.
8. Make sure that the power supply status LED on the power supply is lit and is
If you have other optional devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 39.

Removing a power supply

Important: If the server has two power supplies and you remove either of them, the
server will not have redundant power.
To remove a power supply, complete the following steps:
connector on the power supply.
The following illustration shows the ac power-supply connectors on the back of
the server.
Power-cord
connector
Power supply Power Power
status LED supply 1
supply 2
clamps on the rear of the server, to prevent the power cord from being
accidentally pulled out when you slide the server in and out of the rack.
green, indicating that the power supply is operating correctly.
Release latch
Chapter 2. Installing optional devices
37