Yeti Cycles 303R DH 2013 Owner's Manual page 14

Main Assembly
main assembly Insert the drive and non-drive side specific bearing
9
retainer caps using four M4x.7x12 flat head bolts with a 2.5mm allen
key. Prep the threads with locktite.
Torque 20-25in/lbs.
main assembly Slide the front of the shock into the frame mount.
10
Attach the shock to the frame with a M6 x 31mm Ti female bolt and a
M6x1x12 Ti male bolt. use the guide pin tool to align the shock in the frame
while inserting the female bolt.
main assembly Ensure the female bolt enters the frame through
11
the drive side and that each Ti bolt has the appropriate washer. Apply
locktite to the male bolt and tighten using two 5mm allen keys.
Torque: 100-125 in/lbs.
main assembly Install a locktite prepped M6x1x12 Ti male bolt into
12
a 57.5 Ti stud. Slide a 8.5x12.5x.05mm washer onto the stud so that it
is flush with the head of the Ti male bolt.
assembly 28
main assembly Place the drive
13
and non-drive side eccentrics in the
push links. Align the eccentrics and the
shock using the Fox guide pin tool.
main assembly using a dead
14
blow hammer push the 57.5 bolt
through the eccentrics and shock. use
two 5mm allen keys to tighten the shock
with a M6x1x12 Ti male bolt prepped with
locktite.
Torque 100-125in/lbs.
main assembly Adjust the
15
eccentrics to the desired position
and secure the pinch bolts on the push
links using a 5mm allen key.
Torque 65-70in/lbs
chainstay prOtectOr The 303 RDH has a bolt-on chainstay
16
protector. Install the chainstay protector on the driveside chain stay
using two 4x.7x8 bolts.
Torque 20-25in/lbs