Yeti Cycles 303R DH 2013 Owner's Manual page 13

Assembly
main assembly Place the car mount assembly onto the THk© car
1
and tighten with four M4x.7x8mm bolts. Prep the bolt threads with
locktite. Torque: 20in/lbs.
main assembly Attach the rail sub assembly to the frame with three
2
4x.7x16mm socket head bolts. Prep the bolt threads with locktite.
Tighten the bolts using a 3mm allen key. Torque: 40in/lbs
main assembly Slide the swingarm over the main pivot, using the
3
grooves in the swingarm to properly align over the bore.
main assembly Install the main
4
pivot pin from the drive side using
a dead blow hammer. Be sure to lightly
coat the pivot pin with grease. Thread the
main pivot pin cap into the non drive side
of the pivot pin. use a generous amount
of grease on the male threads. Tighten
the pin and cap with two 5mm allen keys.
Torque 100 in/lbs
assembly 26
thread prep Yeti recommends prepping all threads with
Loctite or grease. The medium strength (blue) formula along
with proper torque is ideal for keep the bolts snug.
main assembly Press a 12.7mm x 18mm pivot pin through each of
5
the bearings located at the top of the seat stays on the rear triangle.
Orient the pin so the exposed female threads are on the inside of the
seatstays.
main assembly Press a push link onto each of the exposed pivot
6
pins in the seatstays. Orient the link so that the pinch bolt is facing
towards the front of the frame. Note that the links are drive and non-drive
side specific.
main assembly Rotate each of
7
the push links towards the front of
the frame and align the bearing in the
link with the pivot pin on the car mount.
Flex the link over the pivot pin on the
car and tap into place with a dead blow
hammer.
main assembly Tighten four male 12.7mm x 12 mm pivot pin caps
8
into the female pivots pins on the push links and car mount. Prep
the male threads with grease. Torque: 65-70in/lbs. At this point the rear
triangle will be able to move freely on the rail system. Ensure the car does
not dent the seat tube.