Assembly
yeti tips
Make sure your tools are in good condition. A
worn allen key can round the hex on a bolt not
allowing for proper torque.
Torque settings are listed throughout the
instructions. It is also import to prep all bolt
threads . The instructions denote whether to use
a blue Loctite compound or grease.
assembly
24
tOOls needed
Dead blow hammer
Two - 5mm allen keys
6mm allen key
4mm allen key
3mm allen key
2.5mm allen key
Grease
Blue Loctite
Guide Pin Tool
time
30-45 minutes depending
on condition of the bike
The linkage tool is necessary to properly
disassemble and reassemble the linkage. using
a hammer to tap out the pin can cause damage
to the linkage and shock.
Not every too may be needed for the assembly/
disassembly of your bike. The list encompasses
all the tools necessary to complete assembly/
disassembly on each bike
Warning:
Service on Yeti bicycles requires special
knowledge and tools. Yeti Cycles recommends that all
service and repairs be performed by an authorized Yeti
Dealer