.0 Installing your Morsø stove
1.1 Unpacking the stove
After removing the outer packaging, flatten it and lay onto the floor close to the stove; this can
then act as protective work surface during the assembly process.
Next, remove the legs and bolts from inside the stove. Gently lay the stove onto its back and
unscrew it from the wooden pallet. Using the bolts supplied, now screw the legs into position
on the underside of the base. The stove should now be lifted and moved into the upright po-
sition, avoiding excess load on the back legs.
The stove is heavy and therefore it is strongly recommended that when lifting, iti is underta-
ken by two people. Morsø 360 weighs 99 kg. Morsø 3640 weighs 09 kg.
1.2 Installing the stove
The stove and chimney installations MUST comply to all current National and Local Building
Regulations; your approved Morsø dealer or your local building control officer can advise
regarding this. Ultimately, it is you and your installer who is responsible that the installation
complies.
1.3 Chimney sweep
It may also be wise to consult your local chimney sweep before installing the stove. After your
stove has been installed, it is advisable to have the chimney checked and swept at least once
a year. In any case, if your chimney has not been used for some time, it should be inspected
for cracking, bird nests, etc. before it is put back into use.
1.4 Stove placement/distance requirements
Clearance requirements apply only if the stove is placed near to combustible materials. Per-
mitted clearances to combustible materials are indicated on the data plate on the rear of the
stove.
Minimum clearances to combustible surfaces:
Stove type
Morsø 360/3640
uninsulated flue
Behind the stove (A) To the sides of the stove (B)
00 mm
360 corner installation
400 mm
3640 corner installation
To soft funushings
000 mm
3