Download Print this page

Installing Your Morsø Stove; Unpacking The Stove; Installing The Stove; Chimney Sweep - Morso 1400 Instructions For Installation And Use Manual

Advertisement

Available languages

Available languages

1.0 Installing your Morsø stove

1.1 Unpacking the stove

Morsø 1416/1418: After removing the outer packaging, unbolt the combustion chamber from the
wooden pallet and place it gently on its back. The cardboard packaging can be placed underneath
to prevent marring. Remove the leg pack from the stove and bolt each leg/panel securely to the
underside of the base on the combustion chamber, using the bolts provided (found inside the stove).
The Heat shield is enclosed between the stove and the wooden packaging. Following the re-
moval of the wooden packaging the heat shield must be fitted to the underside of the stove at
the same time as the legs utilising the same fixing bolts. Please see drawing.
Morsø 1446/1448: Carefully lift the stove from the wooden pallet and set it carefully in place.
We recommend that two people perform the assembly and installation procedure.
The Morsø 1416 weighs 70 kg, while the Morsø 1446 weighs 90 kg.
The Morsø 1418 weighs 74 kg, while the Morsø 1448 weighs 94 kg.

1.2 Installing the stove

The stove and chimney installations MUST comply to all current National and Local Building Regu-
lations; your approved Morsø dealer or your local building control officer can advise regarding this.
Ultimately, it is you and your installer who is responsible that the installation complies.

1.3 Chimney sweep

It may also be wise to consult your local chimney sweep before installing the stove. After your
stove has been installed, it is advisable to have the chimney checked and swept at least once a
year. In any case, if your chimney has not been used for some time, it should be inspected for
cracking, bird nests, etc. before it is put back into use.
1.4 Stove placement/clearance requirements
Minimum Clearance requirements apply if the stove is placed near to combustible materials.
Permitted clearances to combustible materials are also indicated on the data plate on the
rear of the stove.
21

Hide quick links:

Advertisement

Chapters

loading