Installing Your Morsø Stove Page; Unpacking The Stove; Installing The Stove; Chimneysweep - Morso 2110 Instructions For Installation And Use Manual

1.0 Installing your Morsø stove

1.1 Unpacking the stove

2110: After removing the outer packaging, unbolt the combustion chamber from the wooden
pallet and place it gently on its back. The cardboard packaging can be placed underneath to
prevent marring. Remove the leg pack from the stove and bolt each leg/panel securely to the
underside of the base on the combustion chamber, using the bolts provided (found inside the
stove).
We recommend that two people perform the assembly and installation procedure.
The Morsø 2110 weighs 125 kg.
The stove is intended for intermittent use.

1,2 Installing the stove

The stove and chimney installations MUST comply to all current National and Local Build-
ing Regulations; your approved Morsø dealer or your local building control officer can advise
regarding this. Ultimately, it is you and your installer who is responsible that the installation
complies.
1.3 Chimney sweep
It may also be wise to consult your local chimney sweep before installing the stove. After your
stove has been installed, it is advisable to have the chimney checked and swept at least once
a year. In any case, if your chimney has not been used for some time, it should be inspected
for cracking, bird nests, etc. before it is put back into use.
1.4 Stove placement/clerance requirements
Minimum Clearance requirements apply if the stove is placed near to combustible materials.
Permitted clearances to combustible materials are also indicated on the data plate on the rear
of the stove.
Min. afstand til brandbart materiale:
Ovn type Bag ovnen (A) Ved Ovnens sider (B) Above the stove Møbleringsafstand
Morsø 2110
uisoleret røgrør 200 mm 400 mm 500 mm 800 mm
3