Grandstream Networks GXV3275 Administration Manual page 75

Escape # as %23 in SIP URI
Offhook Auto Dial
Offhook Auto Dial Delay (s)
Offhook Timeout (s)
Enable Function for Incoming
Call
Call Function Buttons
Firmware Version 1.0.3.46
It is used to set what characters will be included in the SIP INVITE URI
if end users input #. If it is set to "Yes", the phone system will replace
the # by %23. Otherwise, it will include # in the SIP INVITE message.
The default setting is "Yes".
It is used to configure a User ID/extension to dial automatically when
the phone is offhook. The phone will use the first account to dial the
configured numbers out. The default setting is "No".
It is used to set the timer for warm line dialing. After the timer expires,
the phone system will dial the configured number in Offhook Auto Dial
automatically. If it is not configured, the configured number will be
dialed immediately.
It is used to set the timer for off hook. The phone system will be
automatically on hook if users pick up the handset or turn on the
speaker, and do not take any actions before the offhook timeout
expired (in seconds). The default setting is 30. The valid range is from
10 to 60.
It is used to enable the preview feature for the incoming video calls.
Defines the function for the incoming video call. If it is set to "Preview",
the phone system will pop up the PREVIEW key on the LCD screen
when there is an incoming video call, and users could tap on it to check
video caller without answering the incoming video call.
The default setting is "None".
It is used to configure the buttons displayed on call screen. You can
select three options at most. If select less than three options, it will
automatically display the unchecked options in sequence behind the
selected ones. The default setting is "Hold", "Mute" and "Keyboard".
Note: The settings will not take effect immediately during the call.
GXV3275 Administration Guide Page 73 of 117