Maintenance Page Definition; Maintenance/Network Settings - Grandstream Networks GXV3275 Administration Manual

MAINTENANCE PAGE DEFINITION

MAINTENANCE/NETWORK SETTINGS

Address Type
Enable DHCP VLAN
DHCP Host name (Option 12)
DHCP Vendor Class ID
(Option 60)
IP Address
Subnet Mask
Default Gateway
DNS Server 1
DNS Server 2
PPPoE Account ID
PPPoE Password
Alternate DNS Server
Second Alternate DNS Server
Show IP Address On Account
Widget
Enable LLDP
Firmware Version 1.0.3.46
It is used to configure the appropriate network settings on the phone.
Users could select from "DHCP", "Static IP" or "PPPoE"(Point-to-point
Protocol over Ethernet). By default, it is set to "DHCP".
It is used to configure whether to enable DHCP VLAN function. Once
enabled, the device will use DHCP option 132 (802.1Q VLAN ID) and
DHCP option 133 (QOS priority level) sent by DHCP server to set local
network. The default setting is "No".
It is used to configure the name of the client in the DHCP request. It is
optional but may be required by some Internet Service Providers.
It is used to configure the vendor class ID header in the DHCP request.
The default setting is Grandstream GXV3275.
It is used to configure the phone's static IP address if the static IP is
used.
It is used to configure the network's subnet mask if the static IP is used.
It is used to configure the network's gateway address if the static IP is
used.
It is used to configure the primary DNS IP address if the static IP is
used.
It is used to configure the secondary DNS IP address if the static IP is
used.
It is used to configure the PPPoE account ID if the PPPoE is used.
It is used to configure the PPPoE password if the PPPoE is used.
It is used to configure the secondary DNS IP address if the static IP is
used.
It is used to configure the secondary alternate DNS IP address to
failover during both the default DNS server and alternate DNS server's
outage.
This is used to configure whether to show IP address of the phone on
desktop account widget. The default setting is "Yes".
It is used to enable the LLDP (Link Layer Discovery Protocol) feature
on the phone system. If it is set to "Yes", the phone system will
broadcast LLDP PDU to advertise its identity and capabilities and
receive same from a physical adjacent layer 2 peer. The default setting
is "Yes".
GXV3275 Administration Guide Page 79 of 117