Account Page Definitions; Account/General Settings - Grandstream Networks GXV3275 Administration Manual

ACCOUNT PAGE DEFINITIONS

GXV3275 has six lines that can be configured to accommodate 6 independent SIP accounts. Each SIP
account has an individual configuration page.

ACCOUNT/GENERAL SETTINGS

Account Active
Account Name
SIP Server
SIP User ID
SIP Authentication ID
SIP Authentication Password
Voice Mail Access Number
Name
Show Account Name Only
Tel URI
Firmware Version 1.0.3.46
This field indicates whether the account is active. The default value for
the IPVideoTalk account (Account 6) is "Yes" and the default value for
the first five accounts is "No".
It is used to configure the name associated with each account to be
displayed on the LCD.
It is used to configure the URL or IP address, and port of the SIP
server. This should be provided by VoIP service providers (ITSP).
It is used to configure the user account information, provided by your
VoIP service provider (ITSP). It's usually in the form of digits similar to
phone number or actually a phone number.
It is used to configure the SIP service subscriber's Authenticate ID
used for authentication. It can be identical to or different from the SIP
User ID.
It is used to configure the account password required for the phone to
authenticate with the ITSP (SIP) server before the account can be
registered. After saving, it will appear as hidden for security purpose.
It is used to set if the phone system allows users to access the voice
messages by pressing the MESSAGE key on the phone. This ID is
usually the VM portal access number. For example, in UCM6100
IPPBX, *97 could be used.
It is used to configure the SIP server subscriber's name (optional) that
will be used for Caller ID display. The configured content will be
included in the From, Contact and P-Preferred-Identity headers of SIP
INVITE message.
It is used to select if to display the user ID on the account widget on
the LCD screen. If it is checked, the user ID will be hidden and the
account name will be displayed only.
If the phone has an assigned PSTN telephone number, this field
should be set to "User=Phone". Then a "User=Phone" parameter will
be attached to the Request-Line and "TO" header in the SIP request
to indicate the E.164 number. If set to "Enable", "Tel:" will be used
instead of "SIP:" in the SIP request. The default setting is "Disable".
GXV3275 Administration Guide Page 47 of 117