Reassemble the spout unit in the re‐
verse order. Make sure the top con‐
nection piece engages with a
click. Firmly push the spout jets
onto the dispensing unit.
Make sure that all parts are tightly
connected to one another.
Refit the dispensing unit in the central
spout and touch
Then refit the cover and touch
The central spout will now be rinsed
through.
.
OK
.
OK
Cleaning and care
Sensor cover
The sensor cover for the cup protection
switch-off is located at the base of the
central spout. If the automatic spout
adjustment sensors do not properly
recognise a cup, the cup protection
switch-off will stop the central spout
from lowering.
Clean the sensor cover once a week in
the dishwasher or by hand using warm
water and a little washing-up liquid, ap‐
plied with a soft cloth.
To remove the sensor cover, press
and hold the cover between the
two dispensing spouts. Then press
the sides of the central spout at
the back.
The sensor cover will come off.
To refit it:
Insert both hooks at the back and
press the sensor cover upwards.
65