Maintenance Of The Milk Valve; Sensor Cover - Miele Built-in coffee machine Operating And Installation Instructions

Cleaning and care

Maintenance of the milk valve

The milk valve should be cleaned once
a week to ensure good quality milk
froth.
^ Touch "Main menu" or the
^ Touch "Maintenance"
^ Touch "Clean the central spout".
The central spout and the milk valve will
move into the maintenance position.
Important. You must remove the
cleaning brush before confirming
"Quit maintenance position" with
"OK". Otherwise the coffee machine
will be damaged.
^ Insert the brush in the milk valve and
move it back and forth.
^ Touch "OK".
The milk valve will move into the correct
position and the milk pipework will be
rinsed through.
60

Sensor cover

The sensor cover for the cup protection
cut-out is located under the central
spout. If the automatic spout
adjustment sensors do not clearly rec-
sensor.
ognise a container, this sensor will stop
. the central spout.
If required, the sensor cover can be
cleaned by hand using hot water and a
little washing-up liquid.
^ To remove, press and hold the
This will release the sensor cover.
^ To replace, insert both hooks at the
sensor cover between the dispensers
a. Then press the central spout in
from the sides b.
back and press the sensor cover
upwards.