Sensor Cover; Maintenance Of The Milk Valve - Miele CVA6800 Operating And Installation Instructions

Cleaning and care

Sensor cover

The sensor cover for the cup protection
cut-out is located under the main dis‐
penser. If the automatic dispenser ad‐
justment sensors do not clearly recog‐
nize a container, this sensor will stop
the main dispenser.
If required, the sensor cover can be
cleaned once a week in the dishwasher
or by hand using hot water and liquid
dish soap.
 To remove, press and hold the sensor
cover between the dispenser nozzles
. Then press the main dispenser in
from the sides .
This will release the sensor cover.
Refitting:
 Insert both hooks at the back and
press the sensor cover upwards.
64

Maintenance of the milk valve

The milk valve should be cleaned once
a week to ensure good quality milk froth
without spraying.
The menu is displayed.
Drinks
 Tap
Main Menu
 Select
 Maintenance
the main dispenser
The main dispenser and the milk valve
will move into the maintenance posi‐
tion.
Important! Before confirming the
message in the display with
must remove the cleaning brush.
Otherwise the coffee system will be
damaged.
 Insert the brush in the milk valve and
move it back and forth.
 Tap .
OK
The milk valve will move into the correct
position and the milk pipework will be
rinsed through.
or Back.
and then
Clean
.
, you
OK