Table of Contents
Advertisement
6. Press the up or down arrow button to display the letters and symbols you can use to name the media
set. When you see the desired character, press the right arrow button to move to the next character
position and repeat this step as necessary to complete the setting name. When you finish, press the
OK button.
Note: If you need to delete the previous character, press the left arrow button.
7. Press the up or down arrow button as necessary to select each available media setting and press
the OK button. If necessary, press the
settings.
Parent topic:
Related tasks
Loading Media
Printable Area and Media Size Checking
The left and right edges of media recognized by your product vary depending on the Media Size Check
setting.
• When the Media Size Check setting is turned on, your product automatically detects the left and right
edges of the media within 0.2 inches (5 mm), as long as the media holding plates are attached
correctly.
• When the Media Size Check setting is turned off, your product uses the longest scale on the after
heater label shown here as the standard position for the right edge of the media. The left edge of the
media is determined to be 64 inches (1626 mm) from the standard position for the right edge, no
matter the width of the loaded media. The printable area ranges for the media are described in the
table here.
Note: If you turn off the Media Size Check setting, printing may occur outside the edges of your
media, causing ink to stain the product. Make sure your print data width does not exceed the loaded
media width. When you load media to the left of the right side reference position, adjust the Print Start
Position setting on the product control panel to match the position where the media is loaded.
Media Handling
back button to return to the menu to select additional
43
Advertisement
Table of Contents
