Adjusting Heating And Drying During Printing; Cutting Media - Epson SureColor F9200 User Manual

2. Press the up or down arrow button to adjust the feed depending on these banding results in your
printout:
• If black bands or dark stripes appear, press the up arrow button to increase the feed amount.
• If white bands or pale stripes appear, press the down arrow button to decrease the feed amount.
3. Check the results in your printout and do one of the following:
• If further adjustment is necessary, repeat the last step.
• If the print quality is good, press the OK button.
Parent topic:

Adjusting Heating and Drying During Printing

Follow the steps here to adjust the heating and drying settings during printing.
Note: If the room temperature is too low and a print job with high ink density or a small number of print
passes is sent, the print job may pause while the heater warms up.
1. During printing, press the heat/dry menu button.
2. Press the up or down arrow button to change the heater temperature.
3. Press the OK button.
4. Hold down the
Parent topic:
Related references
Media Setup Menu Settings

Cutting Media

When you finish printing, use a commercially available cutter to cut the media.
Warning: Be careful not to cut yourself when using cutters or other sharp blades. Also be careful
touching areas near the after heater since the after heater may be hot and you could be burned.
1. Press media feed button and press the OK button.
Adjusting the Media Feed
back button until Ready appears on the product control panel.
Media Handling
50