Other Settings; Copy Exposure Adjustment; Card Shot Settings; Add Or Change Extra Preset Ratios - Sharp MXC301W Operation Manual

Other Settings

Copy Exposure Adjustment

This is used to adjust the exposure level when [Auto] is
used for the copy exposure.
Color
Use this to set the copy exposure level in color mode for the
document glass and for the automatic document feeder.
Black & White
Use this to set the copy exposure level in black & white
mode for the document glass and for the automatic
document feeder.

Add or Change Extra Preset Ratios

Two enlargement preset ratios (101% to 400%) and two
reduction preset ratios (25% to 99%) can be added. An
added preset ratio can also be changed.
Preset ratios other than added preset ratios cannot be
changed.

Setting a Maximum Number of Copies

This is used to set the maximum number that can be
entered for the number of copies (number of continuous
copies). Any number from 1 to 999 can be specified.

Initial Margin Shift Setting

This is used to set the default margin shift amount.
Specify a value from 0" (0 mm) to 1" (20 mm) in
increments of 1 mm) for both the front and reverse
1/8" (
sides.

Erase Width Adjustment

This is used to set the default erase width for erase
copy. Specify a value from 0" (0 mm) to 1" (20 mm) in
increments of 1/8" (1 mm) for edge erase.

Card Shot Settings

This is used to set the default original size for the card
shot function.
Both the X (horizontal) and Y (vertical) dimensions of the
original can be set from 1" (25 mm) to 8-1/2" (210 mm) in
increments of 1/8" (1 mm).
Fit to Page
Enable this setting to have the [Fit to Page] key always
appear in the card shot screen.
ID Card Copy Setting
When using ID card copy, you can change the layout
setting of the ID card copy.
For the layout patterns, see the illustrations on page
2-58.
7-71
SYSTEM SETTINGS
Contents