Character Replacement - Datalogic GRYPHON Dx30 Reference Manual

Enter Configuration
Ì$+;Î
T his parameter allows up to three characters to be replaced from the barcode read. These
s ubstitutions are stored in memory. To define each
Read one of the follow ng cha
From the Code Identifier Table in Appendix
code family.
0 = character replacement will be effective for all code families.
From the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE)
which identifies the character to be replaced. For Wedge and USB-KBD interfaces, it is
also possible to read the Special Key(s) on page 67.
From the Hex/Numeric Table read two characters corresponding to the Hex value (00-FE)
which identifies the new character to replace. For Wedge and USB-KBD interfaces, it is
also possible to read the Special Key(s) on page 67.
FF = the character to be replaced will be substituted with no character, that is, it will be
removed from the code.
70
DATA FORMAT
C R
HARACTER
disable character replacement
ÌEO0mÎ
i racter replacement codes:
first c ha r acter repla
ÌEO1pÎ
second character replacement
ÌEO2sÎ
third character replacement
ÌEO3vÎ
EPLACEMENT

character replacement:

cem ent
B
, read the Code Identifier for the desired
Exit and Save Configuration
Ì$-?Î