Installing CMM and CFM Modules
Console Port
Serial Connection to the Console Port
The console port, located on the CMM front panel, provides a serial connection to the switch and is
required when logging into the switch for the first time. By default, this R-J45 connector provides a DCE
console connection.
Serial Connection Default Settings
The factory default settings for the serial connection are as follows:
baud rate
parity
data bits (word size)
stop bits
X-ON/X-OFF
page 3-8
9600
none
8
1
enabled
OmniSwitch 10K Hardware Users Guide
Chassis Management and Fabric Modules
August 2015