Monitoring CMM Modules
Monitoring CMM Modules
Front Panel LEDs
The CMM provides a series of status LEDs on the module's front panel. These LEDs offer basic status
information for the following switch functions:
•
CMM hardware operation
System software
•
CMM processor status
•
•
CMM fabric status
Chassis ambient air temperature
•
Fan status
•
•
Power Supply Unit (PSU) status
Ethernet management port
•
Refer to
"CMM/CFM LED Status Indicators" on page 3-4
Accessing General CMM Information
The switch's Command Line Interface (CLI) offers CMM monitoring commands. These commands allow
you to access general CMM hardware information as well as the current operating status of CMM-related
components.
CMM Hardware Information
The
show cmm
and
the CMM module(s) installed in the chassis.
Use the show cmm command to display the following information:
Model name and description for each CMM
•
•
Part number and serial number
Hardware revision level
•
Manufacture date
•
•
Firmware version number
Administrative and operating status
•
Additional information, such as power control checksum, ASIC information, and chassis MAC
•
Address.
For a detailed information on the show cmm command, including output table descriptions, refer to the
OmniSwitch CLI Reference Guide.
page 3-12
show hardware info
commands are used to display general hardware information for
Chassis Management and Fabric Modules
for information on CMM front panel LEDs.
OmniSwitch 10K Hardware Users Guide
August 2015