Table Of Contents; Important Notes - FocalPoint HANNINGTON Installation & User's Instructions

Inset decorative gas fire
Table of Contents

Advertisement

I N S T A L L A T I O N
Section
Contents
1.0
2.0
3.0
4.0
5.0
6.0
6.1
7.0
8.0
9.0
10.0
11.0
11.1
Operating the fire

1.0 IMPORTANT NOTES

• This appliance is an Inset Decorative Fuel Effect appliance which provides radiant warmth utilising the latest type burner technology.
• The fire is designed to suit various types of fireplaces and natural draught flues as detailed in this manual.
• The appliance must be installed by a competent person in accordance with Gas Safety (Installation and Use) Regulations 1998. It is
strongly recommended that a GAS SAFE registered engineer be used for this purpose.
• Read all these instructions before commencing installation.
• This appliance must be installed in accordance with the rules in force and used only in a sufficiently ventilated space.
• The appliance is designed for installation on to a non-combustible hearth of at least 300mm depth.
• This appliance is factory set for operation on the gas type, and at the pressure stated on the appliance data plate.
• In the event of gas leakage from the appliance, the gas supply must be turned off at the nearest isolating valve.
• The appliance must be installed in accordance with the following:
• Failure to comply with the above could lead to prosecution and deem the manufacturer's warranty invalid.
• The appliance is designed to fit various types of situations as described in sections 3.0 and 4.0.
• Manufacturers' Instructions.
• The Building Regulations issued by the Department for Communities and Local Government, the Building Standards
(Scotland)
(Consolidation) Regulations issued by the Scottish Development Department.
• Relevant British Standards insofar as the relevant areas are not covered by these instructions.
• For Republic of Ireland, reference should be made to the current edition of IS813 (the relevant standards governing
installation).
• It should be noted that heaters create warm air currents. These currents move heat to wall surfaces next to the heater. Installing the
heater next to vinyl or cloth wall coverings or operating the heater where impurities in the air (such as tobacco smoke, candle smoke
etc.) exist, may cause the walls to become discoloured.
• WARNING: The manufacturer of this appliance considers all surfaces as working surfaces with the exception of the control knob
and ash pan door.
• As with any gas fire, a fire guard complying with BS 8423 must be used in presence of pets, children, and the elder-
ly or infirm.
• Consult ALL instructions before installation and use of this appliance.
• This appliance is intended for decorative purposes.
• This appliance is free from any asbestos material.
• Refractories and fuel bed are constructed from ceramic fibre.
Page No.
2
3
3
3
4
4
4
4
5
5
5
5
(Manual Models)
5
(Remote Models)
I N S T R U C T I O N S
Section
12.0
12.1
12.2
12.3
12.3
13.0
13.1
13.2
13.3
13.4
13.5
14.0
2
Contents
(Remote Control Models)
2013 Focal Point Fires plc.
2011 Focal Point Fires plc.
'
'
Page No.
6
6
6
6
6
6
6
7
8
8
8
8

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Taper gas inset tray

Table of Contents