Code Learning; Testing Your Alarm - Mongoose M33 Owner's Operation Manual

REMOTE CONTROL CODE LEARNING
•
If you need to replace a remote control, it must be memorised to the alarm system before it can be used.
•
A power surge or interruption to the power supply may cause loss of memory.
•
If your alarm fails to respond to the remote try re-learning them.
TO MEMORISE A NEW REMOTE:
a) Disarm the system by remote or the override method described on the previous page.
b) Turn the ignition off/on 3 times leaving on third time. Siren will chirp.
c) Press the override switch for 5 seconds - siren chirps 3 times to confirm learning mode.
d) Press button 1 twice on 1
e) Press button 1 twice on 2
Repeat this procedure if you have a third remote. Turn ignition off to complete the learning sequence.
Note: If you lose a remote, re-learning the existing remote will erase the one that is lost.
We strongly recommend that you test your alarm frequently. It takes only a short time and is very important to
maximise the protection of your vehicle.
1. Arm the system. Unlock the door with the ignition key and open the door. The alarm should activate. Check all
the other doors , bonnet and boot by the same procedure.
2. Engine immobiliser. Open the drivers window. Arm the alarm. Without opening a door, reach in and try to start
the engine. It should not start.
3. Shock sensor. Check the shock sensor by giving the vehicle varying degrees of impact.
4. Remote controls. Do not get them wet, drop them on a hard surface or tamper with the internals. To ensure
correct operation at all times, replace the battery every 12 months or sooner if you notice operating range is
reducing.
st
remote. Siren will chirp to confirm.
nd
remote. Siren will chirp to confirm.

TESTING YOUR ALARM

9