Remote 'Code Learning' - Mongoose M40 Operating Instructions Manual

REMOTE 'CODE LEARNING'

The main alarm module has a learning capacity to memorise up to four remote controls.
If you wish to add further remotes, or a remote has to be replaced, the new remote needs to be
memorised into the main module. If for instance you have lost a remote and are fearful that someone
may try to use it, the lost remote can be deleted from memory so it cannot be used.
To learn a remote or add an additional remote:
Disarm the system

Open the drivers door and leave open

Turn the ignition ON/OFF 3 times within 5 seconds (ignition remains off)

The park lights will flash 3 times (and if fitted, the siren will chirp 3 times) and the dashboard

LED will light permanently to confirm you have entered remote code learning mode.
Press button one on the first remote – lights will flash once (optional siren chirps once) as

confirmation of reception
Press button one on the second remote – lights will flash twice (optional siren chirps twice) as

confirmation of reception
Repeat for up to four remotes

Leave the system for 10 seconds or turn ignition ON to complete the process. This is confirmed

by 3 fast light flashes (and 3 chirps if siren connected) and LED off.
NOTE: When learning a new replacement or additional remote, the original remote(s) must
be re-learnt or they will be erased from memory and will not operate this system.
To delete a lost remote from memory:
Enter learning mode as detailed above. Memorise existing remote once. The lost remote is now
deleted. When a replacement is obtained, learn both the existing and new remotes into memory as
detailed above.
(lights flash three times for the 3
rd
remote and four times for the 4th)