Mongoose M18 User Manual

Automatic Keyless-Entry Car Alarm System
PACKAGE INCLUDES
1. Car Alarm Handset x 2
2. Main Unit with Built-in Receiver, including:
A. Main Unit
B. Shock Sensor
C. 131kHz Antenna x 1
Handset
LED
Button Two
(Side Button)
SYSTEM DESCRIPTION
The Mongoose M18 EZ-GO vehicle security system is fully automatic for arming and disarming.
No remote buttons to press as the system in the vehicle scans for your handset.
When you exit and walk at least 2~4 metres away from your vehicle, the security system will arm,
immobilise the engine and lock all the doors automatically when your handset is out of reception range.
When you walk back towards your vehicle and come into the reception range, 2~4 metres depending on
where this units antenna is located in your vehicle, the doors will automatically unlock and the alarm system
disarms – however, the engine remains immobilised until you are ready to start the engine.
The handset can be used as a conventional remote control and a description of the functions are shown
above.
Radio interference:
Due to the nature of this security system, it may be affected by radio interference from other identical
systems or other strong transmission signals. This is not a fault and normally only affects the automatic
proximity function but not the manual remote functions. If your system is affected in the location where the
vehicle is parked, please use the manual remote control functions.
MONGOOSE M18
User Manual
:
x 1
Button
One
D. Override Switch & Wire x 1
E. LED Indicator & Wire x 1
Basic function of button:
Button One ---
a. Arm --- Press once to arm the system
(Chirps once, car lamps flash once)
b. Disarm --- Press once to disarm the system
(No chirp - Car lamps flash twice)
Button Two ---
a. Car finder: Press twice within 3 seconds
(chirps once, car lamps flash six times)
b. EZ-GO disable: Press and hold 2 seconds
(indicators light for 2 seconds)
c. EZ-GO enable: Press once
(indicators light for 1 second)
Button One & Two together
Press both at same time for 4 seconds for channel
2 output (boot release) – optional fitment
- 1 -