Saving The System Data To The Backup Device (Save) - Panasonic KX-TVP200E Installation Instructions Manual

7.1 Utility Commands
Indication
ROM ERROR : Sum Error!!
DISK ERROR : Initialize Error!!
DISK ERROR : No System!!
DISK ERROR : Program Load Error!!
DISK ERROR : Program Sum Error!!
DISK ERROR : System Data Error!!
SYSTEM ERROR : 1
SYSTEM ERROR : 2
SYSTEM ERROR : 3
SYSTEM ERROR : 4
SYSTEM ERROR : 5
SYSTEM ERROR : 6
SYSTEM ERROR : 7
SYSTEM ERROR : 8
SYSTEM ERROR : 9
SYSTEM ERROR : 10
SYSTEM ERROR : 11
SYSTEM ERROR : 12
SYSTEM ERROR : 13
SYSTEM ERROR : 14
No CO line cards are active!!
COs are all Disable!!
DPITS Interface Connection is not Established.
Error and warning indications during system operation
Indication
DISK STORAGE SPACE IS NOW EXCEEDING 80%...
ASCII TERMINAL program Load Error
VT100 program Load Error

7.1.7 Saving the System Data to the Backup Device (SAVE)

All system programming data and voice prompts can be backed up in separate data
files on a data terminal connected to the RS-232C port of the VPS. You cannot
back up all of them at the same time; they must be saved individually.
The SAVE command can be executed for each data file. It may take some time to
complete SAVE for all the data. When performing this operation please wait until
the process completion indication appears.
Meaning
ROM checksum error.
HDD initialization error.
No system HDD present.
Program could not be loaded from system HDD.
Checksum error in program loaded from system HDD.
Error loading of administrator data from system HDD.
Administrator data error.
Error loading of report data.
Clock error.
Mailbox data error.
Message data error (1).
Message data error (2).
Error loading of control data.
Error loading of voice prompt data.
Error loading of MWL control data.
Error loading of disk identify data.
Error writing of VBI chain data.
Error writing of BLK chain data.
Error loading of user prompt modify data.
Error loading of Class of Service data.
No Port cards present.
All Port cards are malfunctioning.
Port cards are malfunctioning for DPITS because
telephone lines are disconnected or Integration with PBX
is not set to D-PITS mode.
Meaning
80% or more of the HDD voice message save area is used.
Error loading of ASCII terminal control program.
Error loading of VT100 control program.
7-7
Maintenance