Saving The System Data To The Backup Device (Save) - Panasonic KX-TVS75 Installation Manual

7.2 UTILITY COMMANDS

7.2.7 Saving the System Data to the Backup Device (SAVE)

All system programming data and voice prompts (7 functional areas) can be saved in separate
data files. To save this data, a data terminal must be connected to the RS-232C port of the VPS.
Files must be saved individually. The SAVE command must be executed for each data file. It
will require several minutes to SAVE for all the data selected. When performing this operation,
always wait until the process completion indication appears.
WARNING
Never save (back-up) and upload the "Program" without Panasonic Technical support.
The memory required to save each data component is indicated below.
TVS75/100
1. Program - approximately 1 Mbytes (See Warning above)
2. Parameters - approximately 0.3 Mbytes (System Configuration)
3. System Prompts - approximately 15 Mbytes (Do not save - prompts are saved
as defaults on the drive)
TVS200
1. Program - approximately 2 Mbytes (See Warning above)
2. Parameters - approximately 0.8 Mbytes (System Configuration)
3. System Prompts - approximately 28.5 Mbytes (Do not save - prompts are saved
as defaults on the drive)
Saving items 4-8 below will depend upon the length of the recorded messages.
4. User Prompts-1 (Modified prompts - Modifications to default settings)
5. User Prompts-2 (Modified prompts - Modifications to default settings)
6. Custom Service Menu (Customer service recordings)
7. Personal Greeting (Subscriber greetings)
8. Company Greeting (TVS200 only)
1.
Type SAVE, then Press RETURN.
$ SAVE
VPS Disk Data Save (VPS -> PC : Xmodem)
1: Program
2: Parameters
3: System Prompts
4. User Prompts-1
5. User Prompts-2
6. Custom Service Menu
7. Personal Greeting
8. Compary Greeting
Select No. :=
144
SYSTEM MAINTENANCE AND TROUBLESHOOTING