Utility Command List (Help); Quick Setup (Qset) - Panasonic KX-TVP200E Installation Instructions Manual

7.1 Utility Commands

7.1.16 Utility Command List (HELP)

The HELP command displays the list of all available utility commands.
1
Type "HELP", then press [RETURN].
$ HELP
OFLN : System Off-line
ONLN : System On-line
PASS : Password setting
TIME : Time & Date setting
PSET : Report Print Out Time setting
ELOG : Device Error Log Listing
SAVE : VPS Program & Data Save (VPS → PC : Xmodem)
LOAD : VPS Program & Data Load (VPS ← PC : Xmodem)
GPRN : Parameter Global Printing (only 'ASCII Terminal' mode)
VERS : Program Version Check
CREP [no]
CCLR [no]
MWL
MRL
MPLT [opt]
QSET : Quick Setup
LMON : Line Monitor
PUTD : DTMF Information Display (Don't leave enabled after
troubleshooting.)
$

7.1.17 Quick Setup (QSET)

Used to set up your VPS very roughly when you use your VPS for the first time or
after system initialization.
Type "QSET", then press [RETURN].
You will see the same menu as "Starting the Quick Setup" in Chapter 4.
To proceed, go to page 4-8.
7-14
Maintenance
: Custom Menu Information List
[no] : Custom Menu No. (1-100)
: Custom Menu Access Counter Clear
[no] : Custom Menu No. (1-100/0) (0: Clear All)
: MWL Retry count Set (1-3)
: Minimum Recording Length Set (0-3)
: Registered User Prompt No. List
→ User Prompt 1
[opt] : 1
→ User Prompt 2
2
None → User Prompt 1&2