Using Your Monitor For The First Time; Installing The Batteries; Setting The Date And Time - Microlife BP3NA1-1X Instruction Booklet

b) Wide Range Rigid Cuff:
For arm circumference 22cm - 46 cm (8.7" - 18.1")
If you ever need to buy a replacement cuff, use only Microlife
brand cuffs. Call Microlife customer service at 1-800-568-4147
for information.
Please Note:
rm circumference should be measured with a measuring tape in the middle of the relaxed
upper arm. Do not force cuff connection into the opening. Make sure the cuff connection is
not pushed into the C adapter port. If the cuff is too small, call 1-800-568-4147 for further
information. You may prefer to use one of our wrist type monitors.

4. Using your Monitor for the First Time

4.1 Installing the batteries

Insert batteries immediately after unpacking the unit. The
battery compartment is located on the bottom of the device.
a) Remove cover.
b) Insert the batteries (4 x size
observing the indicated polarity.
c) If a battery warning appears in the display,
the batteries are discharged and must be replaced.

4.2 Setting the date and time

1. fter the new batteries are activated, the year number flashes in
the display. You can advance the year by pressing the "M" but-
ton. To confirm and then set the month, press the time button.
2. You can now set the month using the "M" button. To confirm
and then set the day, press the time button.
3. Please follow the instructions above to set the day, hour and
minutes.
4. Once you have set the last minute and pressed the time button,
the date and time are set and the time is displayed.
5. If you want to change the date and time, press and hold the time
button down for approx. 3 seconds until the user icon starts to
flash. Release and press the time button once more and the
year will begin flashing. Now you can enter the new values as
described above.
6
1,5V),
Memory
Button
Time/Date
Button
TIME PM