Installing Firebox Using Optional Pre-Built Mantel Cabinets - Kingsman ZVF33 Owner's Operation And Installation Manual

INSTALLING FIREBOX USING OPTIONAL PRE-BUILT MANTEL CABINETS

This firebox may be installed using a cabinet mantel accessory against a wall in your home. The firebox and cabinet mantel
can be installed directly on the floor.
1. Assemble cabinet mantel. Assembly
instructions are included with each accessory.
2. If using an optional Blower, install a properly
grounded, 120 volt three-prong electrical
outlet. See Installing optional Fan Kit, page
35, for complete installation. If possible,
locate outlet so cabinet mantel will cover it
when installed (see Figure 9).
3. Install gas piping to firebox location. See
Installing Gas Line, page 20. You may have
to cut an access hole in the floor or wall to
run gas line to firebox. Make sure to locate
access hole so cabinet mantel will cover it
when installed (see Figure 9).
4. Place cabinet mantel on floor in desired
location. Make sure mantel is flush against
wall.
5. Carefully insert firebox into cabinet mantel.
Be careful not to scratch firebox, cabinet
mantel, flooring, etc. when installing.
6. Install and properly test gas log heater. Follow
installation instructions included with the
vent-free gas log heater that is being installed.
NOTICE
A qualified service person must install firebox. Follow
all local codes.
WARNING
Any changes to this heater or its controls can be
dangerous.
NOTICE
Installation and repair should be done by a qualified
service person well trained in the installation of such
appliances. You will also need a building permit from
your local Building Commissioner before installing this
appliance, otherwise your insurance company may not
cover this appliance.
INSTALLING – Mantel Cabinets
FIGURE 9 – Installing Cabinet Mantel
CARBON MONOXIDE POISONING
MAY LEAD TO DEATH!
Use new black pipe only. Internally tinned copper
tubing can be used in some areas when permitted by
local codes. Only use pipe of 1/2" or greater diameter
to allow full gas volume to heater. Excessive pressure
loss will occur if the pipe is too small.
A manual shutoff valve, union and plugged
pressure tap pointer must be installed upstream of the
heater.
A sediment trap must be installed upstream of the heater
to prevent moisture and contaminants from passing
through the pipe to the heater controls and burners. Failure
to do so could prevent the heater from operating
reliably.
19
DANGER
CAUTION
1 ⁄ " NPT
8