Snap Disc & Side Panel Installation; Blower Installation - Quadra-Fire 31I-ACC Owner's Manual

3100-I ACC Wood Insert
I. Snap Disc and Side Panel Installation
1. Place snap disc box in location shown in Figure 42.1.
2. Secure the wires through the wire clip to keep in place.
. Route the blower wires underneath appliance through
the wire channel to the other side of the appliance.
Blower Wires
Figure 42.1
J. Blower Installation
1. Remove top and bottom screw from inner panel.
2. Slide blower mount with blower attached behind the
face and secure with 5 screws provided,  on the right
side and 2 on the left. Figure 42.2.
. Connect the blower to the wire harness and secure
through the wire clip.
4. Install left side panel.
CAUTION
Shock Risk.
• Do NOT remove grounding prong from plug.
• Plug directly into properly grounded  prong
receptacle.
• Route cord away from appliance.
• Do NOT route cord under or in front of appliance.
Page 42
4. Tilt the side panel forward under the top and push the
panel onto the pegs on the face.
5. Attach the side panel to the appliance with 2 screws, 1 at
the top and 1 at the bottom on the right side of panel.
6. Repeat for other side once the blower has been
installed.
Face Pegs
Wire Channel
Left Side
Panel Screws
Figure 42.2
7044-140B
Wire Clip
Snap Disc Box
Inner Panel
R
Side Panel
Screws
Blower
Mounting
Screws
Wire Clip
February 10, 2010