Charging Program - Skyrc B6AC+ DUAL POWER Instruction Manual

8. Program Stop
During the charging process, press STOP to stop the charging process.
9. Program Complete
When the charging process finishes, an audible sound will be heard.

Charging Program

Depends on different battery type, the operation programs are different.
Batt Operation
Type Program
CHARGE
DISCHARGE
STORAGE
LiPo
FAST CHG
Lilon
LiFe
BAL CHARGE
CHARGE
AUTO CHG
DISCHARGE
NiMH
RE-PEAK
NiCd
CYCLE
CHARGE
Pb
DISCHARGE
B6AC+ V2
This charging mode is for charging LiPo/LiFe/LiIon battery in normal mode.
This mode is for discharging LiPo/LiFe/LiIon battery.
This program is for charging or discharging lithium battery which
will not be used for long time.
The charging capacity may be a bit smaller than normal charging
but the process time will be reduced.
This mode is for balancing the voltage of lithium-polymer battery
cells while charging.
The charger will charge NiMH and NiCd batteries using the
charge current set by the user.
In this program the charger detects the condition of the battery
which is connected to the output and automatically charges the
battery.
Note: you should set up the upper limit of the charge
current to avoid damage by excessive feeding current.
Some batteries of low resistance and capacity can lead to
higher current.
This mode is for discharging NiMH/NiCd battery.
In re-peak charge mode, the charger can peak charge the
battery once, twice or three times in a row automatically. This is
good for confirming the battery is fully charged, and for checking
how well the battery receives fast charges.
1 to 5 cyclic and continuous process of charge>discharge or
discharge>charge is operable for battery refreshing and
balancing to stimulate the battery's activity.
This mode is for charging Pb battery.
This mode is for discharging Pb battery.
OPERATING PROGRAM
Description
13 ·