Accuracy Inspection And Adjustment (Camera Body) - Nikon D70 VBA10401 Repair Manual

Accuracy inspection and adjustment (Camera body)

・ To connect to PC, as shown below, connect MC-31 (J19109) to the connector of RS232 on PC, then attach
the communications tool (newly prepared as RP) (J61205) to the connection FPC of camera.
(Refer to next page for how to connect J61205)
Stabilized power supply
Set value ＝ 9.0V、 0.5Ω
5.0A
or AC adapter EG-5
＊ Note:
When checking "battery check",
be sure to use the battery tool
(J61167).
Flash meter
Not prepared as RJ
AF50/1.4D
Battery tool
J61197
Note)
When connecting to PC by the
communications tool (J61205)
with the memory compression
PCB attached, be sure to
remove the ＊ -marked FPC
from the connector on Page
A41.
Shutter tester (EF-8000, etc)
- Ａ35 ･
Connection FPC
J61205
In case of 9 pin type terminal of
RS232C, connect by using 25
pins - 9 pins converting connector.
But this is not provided by RJ, so
use goods on the market.
-
VBA10401-R.3623.A
AECCD
alignment tool
(J15411)
J19109
To RS232C terminal
J18361
D70 inspection and adjustment
software