Ccd-Pcb Eeprom Flashram Up; Tft Pcb Eeprom Flashram Up - Nikon D70 VBA10401 Repair Manual

(7) TFT view angle adjustment
This is for adjusting the display position of TFT. Make an adjustment only for NTSC. (Unnecessary for
PAL)
(8) CCD-PCB EEPROM flashram up
Copy the EEPROM value of the CCD-PCB into the flash memory of the memory compression PCB (AK
PCB).
The flashram up is necessary when the memory compression PCB (AK PCB) is replaced.
The shooting image-related adjustment values are stored in EEPROM of the CCD-PCB, but the camera
does not directly access the CCD-PCB EEPROM. It does read out the value, which is stored in the flash
memory of the AK PCB of the memory compression PCB, and go to RAM to operate. Therefore, to reflect
the adjustment value, it is necessary to copy the stored value of the CCD-PCB EEPROM into the flash
memory.
※ When the shooting image adjustments of each (1) - (3) are completed, the software automatically
performs the flashram-up.
(9) TFT PCB EEPROM flashram up
Copy the EEPROM value of the TFT PCB, as performed in the above CCD-PCB, into the flash memory.
It is necessary to flashram up when the TFT PCB is replaced.
※ When the TFT view angle adjustment is completed, the software automatically performs the
flashram-up.
(10) Reading of RISC version
Display the RISC firmware version.
- Ａ52 ･ -
VBA10401-R.3623.A