Rear Housing Removal - Polaris 2009 Trail Boss 330 Service Manual

FINAL DRIVE
11. Install the chain guard if previously removed.
Install the bolt and spacer to secure the chain
guard into place.
12. Apply Anti--Seize lube to the axle splines. Install
the rear wheel hubs on both sides.
13. Install flat washer (I), cupped washer (m) and hub
nut (J). Torque the hub nut to 80 ft.lbs. (109 Nm).
Install a new cotter pin (K).
K
7.10
I
M
J
80 ft.lbs.
14. Install the rear wheels and torque wheel nuts to 50
ft. lbs. (68 Nm).
Rear Wheel
Rear Hub Nut
80 ft. lbs. (108 Nm)
15. Lubricate the axle housing through the grease
fitting with Polaris All Season Grease (PN
2871423).
CONCENTRIC SWINGARM

REAR HOUSING REMOVAL

1. Remove rear axle.
2. Remove the caliper mounting bracket (A) from the
side of the axle housing.
3. Remove the rear housing from the swingarm.
4. Inspect housing for cracks or wear. Replace if
damaged.
Rear Wheel Nuts (4)
50 ft. lbs. (68 Nm)
Taper end faces
wheel for install.
A