Transmission Lubrication - Polaris 2009 Trail Boss 330 Service Manual

MAINTENANCE

TRANSMISSION LUBRICATION

The transmission lubricant level should be checked
and changed in accordance with the maintenance
schedule.
G Be sure vehicle is level before
proceeding.
G Check vent hose to be sure it is
routed properly and unobstructed.
G Follow instructions on following
pages to check
transmission lubricant.
TRANSMISSION SPECIFICATIONS
Specified Lubricant:
Polaris AGL Gearcase Lubricant:
(PN 2873603) (Gallon) (PN 2873602) (12 oz.)
Capacity: 11.3 oz. (335 ml)
Drain Plug / Fill Plug Torque:
14 ft. lbs. (19.4 Nm)
To check the level:
1. Remove dipstick and wipe clean.
2. Reinstall dipstick completely, remove and check
the level. Add the proper lubricant as required to
bring level into operating range as shown.
2.12
/ change
TRANSMISSION FLUID
CHANGE/TORQUE STOP
ADJUSTMENT
1. Remove skid plate (if necessary).
2. Place a drain pan beneath the transmission oil
3. Loosen jam nut (A).
4. Turn adjuster bolt (B) in to allow the removal of
5. Remove the drain plug and wipe the magnetic end
6. After the oil has drained completely, install a new
Transmission
7. Turn adjuster bolt (B) out until it touches the
Dipstick
8. Tighten the jam nut securely while holding the
9. Add the proper lubricant through the dipstick hole
10. Check for leaks.
11. Reinstall skid plate if removed in Step 1.
Full
Operating
drain plug area.
drain plug.
clean to remove accumulated metallic filings.
sealing washer and install the drain plug. Torque
to 14 ft. lbs. (19.3 Nm).
frame, and then an additional 1/2 turn.
PVT Cover
B
A
Forward
adjuster bolt.
until the oil level is between the upper and lower
limits. Do not overfill.
Range
Drain Plug