Polaris 2009 Trail Boss 330 Service Manual page 201

PDM SPECIFICATIONS
Characteristic
Operating Temperature
Storage Temperature
Characteristic
Battery Voltage
Batt. Quiescent Current
REGULATOR
Regulator Voltage
Regulator Output
Minimum Battery
Voltage
Alternator Coil 1 Resist-
ance
BAT_PROT OUTPUT
Output Current
Limit
Time Delay
Voltage
ACC_PWR OUTPUT
Output Current
Nominal Current
Overload Current
Peak Current -- Hard-
ware
Power Off Delay
LIGHTS OUTPUT
Output Current
Current Limit
Repetitive Short Circuit
Limit
Inrush Time
Parameter Unit Note
--40 to +55 dC Ambient temperatures at which module should remain
within specified limits
--50 to +85 dC Ambient temperatures which should have no adverse ef-
fects on module operation
MIN TYP MAX UNIT
7 14.4 16 Vdc
2
14.1 14.4 14.8 Vdc
18 Vdc
4.5 5.0 Vdc
14.7k 15k 15.2k ohm
8 Amp
9 11 20 Amp
100 150 mSec Time above limit until SSCB trips
5.5 Vdc
10 Amp
9 11 14 Amp
13 16 19 Amp
31 50 65 Amp
7 10 13 Sec
18 Amp
40 65 65 Amp
65 Amp
50 100 500 mSec Inrush time delay.
Note
PDM functions will operate over this range
mA Min. draw from battery with key off
Max. total DC amperage available from regulator
Min. voltage required on RUN for regulator to be-
gin operation
Resistance between alternator signal and ground
Only on this designated alternator signal
Nominal Continuous output current
Current level that will cause turn off after delay
Min Battery voltage for BAT_PROT to remain on
Max. continuous current
Current above which the output will shut off after
15 -- 25 seconds
Current above which the output will shut off after
1.5 -- 2.5 seconds
Initial peak short circuit current limit above which
the device will current limit then quickly shut down
Delay after run switch is turned off
Max. continuous current
Current limit above which device will shut down
within thermal shutdown time
Current level that will cause turn off and on after
delay
ELECTRICAL
10.9