OSD Menu Features
MAIN MENU
System Information
Display Setting
System Setting
IR LED Setting
Restart Camera
Reset
SYSTEM INFORMATION
Protocol
Baud Rate
Hard Addr
Soft Addr
Enable Soft Addr
Temperature
Version
DISPLAY SETTING
Info Tip(s)
PTZ Display(s)
RESTART CAMERA
Select to restart the zoom module.
RECOVER FACTORY SETTING
Select to load all factory default settings, power the camera down to take effect.
Display system information
Configuration of on-screen information
Configuration of system parameters
Configuration of IR illumination parameters
Restart the zoom module
Revert to factory default settings
Set control protocol to Pelco/Hik/Auto
Set control baud rate to 2400/4800/9600/Auto
Display current address/ID set by DIP switches (0-255)
Configure a new address/ID to override Hard Address (0-255)
Enable the Soft Addr function
Display current internal temperature of camera
Display current firmware version
Configure on-screen information such as Preset and Pattern
functions. Can be set to never time-out or1-5s time-out.
Configure on-screen PTZ directional info. Can be set to never
time-out or1-5s time-out.
9