Setting Up The Printer On A Network; Connecting To The Network - Epson Stylus Pro 3880 User Manual

Chapter 1:
Setting Up
the Printer On
a Network
Note: You must use a
Category 5 shielded
twisted-pair cable to
connect the network
interface to prevent
malfunction. You can use
both 10Base-T and
100Base-TX networks.
When you print a lot of
data, we recommend using
the highest speed available
for your product with light
network traffic.
If you are using the printer on a network, follow the instructions in this
chapter to:
Connect the printer to the network
•
Configure the network interface
•
Install the printer software
•
To connect the printer directly to your computer's USB port, see the
Start Here sheet.

Connecting to the Network

Make sure you have the correct cable for connecting the printer. To connect
to a network switch or hub, you need a standard RJ-45 "straight-through"
network cable. To connect directly to your computer's network interface,
you need an RJ-45 crossover cable.
1. Turn off the printer.
2. Connect one end of the appropriate cable to the printer's Ethernet port.
Then connect the other end to your network switch or hub or your
computer's Ethernet port.
3. Turn on the printer.
Once the printer is connected to your network, you need to configure it. See
"Configuring the Network Interface" on page 16 for instructions.
15
15