Configuring The Network Interface - Epson Stylus Pro 3880 User Manual

16 | Setting Up the Printer On a Network
Note: If you don't know
which setting to use, see
your network administrator
for help configuring the
printer's IP settings.

Configuring the Network Interface

1. Make sure that the printer is turned on and the LCD displays
2. Press the r button on the printer's control panel to enter the
Menu
printer's menu system.
3. Press d to highlight
4. Press r then d to highlight
5. Press Enter. An asterisk (*) appears next to
selected.
6. Press l to go back, then press d to highlight
7. Press r, then press u or d to choose one of the following IP
configuration settings:
Select this setting if your network uses a DHCP server to
• AUTO:
provide IP addresses automatically. The printer's IP address will be
obtained from the DHCP server whenever the printer is reset or
turned on.
Select this setting if you would like to configure the
• PANEL:
printer's IP settings manually.
Select this setting to set the printer's IP address using the arp
• PING:
command. The IP address is set when the printer is turned off and
then back on.
8. Press Enter. An asterisk (*) appears next to the setting you selected.
9. Press l to go back, then do one of the following:
If you selected
•
+ Cancel/Reset button to exit the printer menu. Then continue
with step 14.
If you selected
•
with step 10.
If you selected
•
+ Cancel/Reset button to exit the printer menu. Print a network
status sheet to determine the printer's MAC address (see "Printing a
1-16
NETWORK SETUP
ENABLE.
as the IP ADDRESS SETTING, press the
AUTO
as the IP ADDRESS SETTING, continue
PANEL
as the IP ADDRESS SETTING, press the
PING
READY
, then press r.
to show that it's
ENABLE
IP ADDRESS SETTING
.
.