TM-T20II Software Installer
E
Click the Serial port button. Configure the communication settings, then click the Next button. Proceed to
Step 8.
Select the COM port, Bits per second, Data bits, Parity and Stop bits.
Note:
The driver's serial communication setting should be the same as that of the printer.
F
Click the Ethernet button.
When printer is already networked
When using Ethernet
When configuring the network setting after
installing the driver.
Note:
When the EpsonNet Config is not installed, the Cannot start EpsonNet Config. Do you want to install it now?
message appears. Click the Yes button to install it.
Software User's Manual
Installation
Proceed to Step 7.
Click the Run EpsonNet Config button and configure the
printer's network setting using the EpsonNet Config.
U See
page 18
Proceed to Step 7.
"Network Address Setting for Ethernet Printer" on
15