Epson Stylus Pro 3880 User Manual page 17

Network Status Sheet" below). Then use the arp command to set
the IP address from a computer on the same segment of your
network as the printer. Type the arp command on the command
line using this format (where X is the IP address you want to assign
and Y is the MAC address):
arp -s XXX.XXX.XXX.XXX YY-YY-YY-YY-YY-YY
After typing the command, continue with step 14
10. Press d to highlight
displays the
IP ADDRESS
11. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press
LCD displays the
12. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press
LCD displays the
13. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press
then press the Cancel/Reset button to exit the printer menu.
+
14. Turn the printer off then back on again.
15. See "Printing a Network Status Sheet" below to print a network status
sheet and confirm the new IP address. For Windows, you'll need the IP
address during setup.
Now you can install the printer software (see "Installing the Printer
Software" on page 18).
1-17
Setting Up the Printer On a Network | 17
IP, SM, DG SETTING
.
.
SUBNET MASK
DEFAULT GATEWAY
, then press r. The LCD
.
. The
r
. The
r
Enter,