How To Assemble - Eureka 96 Owner's Manual

8
ENGLISH

HOW TO ASSEMBLE

Assemble completely and charge batteries for 14-16 hours
before using.
CAUTION: Use only Eureka model UA100025b charger.
Have a screwdriver available for assembly (not included).
Attach Handle Grip
Step 1: Locate the 2-part bolt
Step 2: Align the handle grip and handle tube holes and secure
with the 2-part bolt
Note: The single hole in the handle tube faces
forward in relation to the handle grip.
Attach Handle
(Fig. 2)
Step 1: Use your thumb to pull back on the lock button
Step 2: Push handle G into top of cleaner.
AA
Step 3: Release lock button
it locks into place.
Secure Wall Bracket on Wall
Have a 1/4 inch drill available for assembly (not included).
Cleaner hangs in bracket with the nozzle end down. Mount on a
wall in close proximity to an electrical outlet where there are not
dangerous objects hidden beneath the wall surface like electrical
wires, pipes, etc. Leave 14 inches above the floor for clearance.
Step 1: Hold bracket I against wall to mark location for
AA
screws. Make sure the wall bracket is positioned verti-
cally, with the charger socket at the bottom.
Step 2: Use a 1/4 inch drill for drilling holes for the plastic
anchors N .
AA
Step 3: Insert the anchors
both holes.
Step 4: Tighten the screws
Step 5: Place cleaner, with the nozzle pointed down, on the
wall bracket I .
AA
Step 6: Plug the charger
Note: This charger has been designed to use as either
a wall mounted charger or to sit on a counter or
shelf P . To use on a counter or shelf, locate next
AA
to an electrical outlet. Take the battery
the cleaner and put in the counter bracket
4).
(CONTINUED)
(Fig. 1)
H in the assembly package.
AA
H . Tighten the bolt
AA
M and rotate handle
G
AA AA
(Fig. 3)
N and drive the screws
AA
O to secure the bracket
AA
L into an electrical outlet.
AA
C
AA
M .
AA
until
O into
AA
I .
AA
out of
I (Fig.
AA