Problem Solving - Eureka 96 Owner's Manual

ENGLISH

PROBLEM SOLVING

Note: Turn off the switch and unplug the electrical cord before servicing.
Problem
Cleaner will not run
Cleaner only runs
a short time
Battery will not charge
Will not pick up
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
16
Cause
Battery low
Battery not installed correctly
in cleaner
Low battery charge
Charger not connected
to power supply
Battery life depleted
Low Battery
Dirty Filter
Brushroll clogged
Air path clogged
Solution
• Charge Battery
• Reinstall battery and firmly press in place
• Charge battery
• Plug in Charger
• Replace battery
• Charge Battery
• Clean Filter
• Remove hair, string, lint from brushroll
• Remove clog from air path